40" Longboard Deck constructed of 7 Ply Canadian maple.
Wireless 2.4G Controller for Best Performance. Rechargeable Using Micro USB Recharge Socket (Comes with Cable), Thumb Wheel Accelerator and Break (Forward to Accelerate, Back to Break), Gear Button With 3 Speed Modes. Forward/Reverse Switch, 4 LED Display (labelled Board Power Indicator below) Indicates Speed Selection, Direction of Travel and Battery Level. 2 Separate LED Indicate Charge (Red for Low, Green for Charged) and Connectivity (Signal, will flash when not connected). Remote Will Operate at a Distance of 10M.
Works with A Sinusoidal Wave Drive and Hall Sensor to Ensure Smooth Acceleration and Breaking. The 2.4G Antenna is Constructed Into the ESC, Solving Any Issues Signal Reaching the Control Circuit.
7,ALLUMINUM ALLOY COVER:
MADE OF ALUMINUM ALLOY, THE COVER IS VERY STRONG AND UNBREAKABLE. ALUMINUM ALSO ALLOWS FOR GREATER HEAT DISSIPATION FROM THE BATTERY PACK AND CONTROL CIRCUIT.
ALLOY+RUBBER ANTI-SKID AND SHOCKPROOF
BIG ADVANTAGES: IT IS VERY EASY SWITCH FROM OFF -ROAD WHEELS TO HIGHWAY WHEELS.
WHAT'S INSIDE THE BOX?
1 x ready-to-Skate AEboard Electric Skateboard AT1 1 x power Adapter and Charger 1 x Wireless Remote & USB Cable 1 x T Wrench (with 3 Socket Sizes and HexKey/Screwdriver)
AEboard has been fully resisted before receiving the goods, but once you start using or maintaining it or replacing the battery, the board's water resistance will be reduced. Water can damage the board and water damage is not covered by the warranty. Therefore, you should avoid placing the board in the water.
Always wear a helmet and suitable safety equipment when riding an electric skateboard.
Remember to turn off the remote and charge it when not in use to extend battery life.